kits ... forum ... about us ... contact ... license ... 4ms Pedals

Finishing the board

  • On the soldering side of some boards, you need to put down some additional wires or trimpots
  • The wires are indicated by grey curvy lines on the soldering side (e.g. the phaseur needs 8 or so). Just cut a piece of wire the right length, strip the ends 1/16” inch, and solder it onto the twisted wire joints.
  • For trimpots, solder two of the leads (the center one and one other) directly to the two twisted wire joints on the solder-side. Make sure it won’t wiggle around.


commonsound/finishing_the_board.txt · Last modified: 2005/09/04 13:38
Recent changes RSS feed Driven by DokuWiki