commonsound forum: Noise Swash => Confused Amatuer

commonsound

kits ... forum ... about us ... contact ... license ... 4ms Pedals

Members

FUDforum help

Home

Building How-to » Noise Swash » Confused Amatuer

Show: Today's Messages :: Show Polls :: Message Navigator

E-mail to friend

Confused Amatuer [message #1674]

Thu, 16 August 2007 16:25

Jezi
Messages: 7
Registered: August 2007

Junior Member

Hallo there, it's been a while since I bought the noise swash and the triwave. NOW it's time to finished it up and I'm getting confused putting all the parts on the noise swash. All the parts are done except Self Osc and LFO on/off stomp and switch respectively.

Question; What do i solder on the Self-Osc stomp switch and the LFO on/off switch? There are 6 holes each but on the stomp there are 9.

I think that on the LFO on/off i need to solder 3 cables to the board. But to which connections on the switch?

I don't seem to find any answer anywhere in the build page. Please help. I wanna get the noise swash done and then move on to the triwave.

regards
Dennis

Report message to a moderator

Re: Confused Amatuer [message #1675]

Thu, 16 August 2007 16:26

Jezi
Messages: 7
Registered: August 2007

Junior Member

Oh i forgot to add, I'm using a PCB 2.2, 2004.

Report message to a moderator

Re: Confused Amatuer [message #1696]

Sun, 16 September 2007 21:32

dann
Messages: 829
Registered: December 2002
Location: Austin TX

Senior Member

for self-osc stomp and LFO stomp, you only use 6 of the holes on the stomps. Which 6? If this is your stomp switch:

-- -- --
-- -- --
-- -- --

...use any two vertical columns, it doesnt matter which ones.

Note that the stomp switch wiring is orientated the same way for the Bypass stomp and the Self-osc and LFO stomps..

Report message to a moderator

Previous Topic:	Swash Touch-Up Tweaking?
Next Topic:	Trouble getting a swash to work

Goto Forum:

-=] Back to Top [=-

Current Time: Sun May 19 21:18:56 EDT 2013

.:: Contact :: Home ::.