commonsound forum: Kits (obsolete!) => Where in the diagram can I add an LED?

commonsound

kits ... forum ... about us ... contact ... license ... 4ms Pedals

Members

FUDforum help

Home

General » Kits (obsolete!) » Where in the diagram can I add an LED?

Show: Today's Messages :: Unanswered Messages :: Show Polls :: Message Navigator

E-mail to friend

Where in the diagram can I add an LED? [message #828]

Wed, 08 September 2004 21:23

beekhay
Messages: 1
Registered: September 2004
Location: Brooklyn, NY

Junior Member

I bought a Noise Swash kit a while back (2 years?) and am finally getting around to building it. I'm a novice so I need some pointers. Can someone tell me how to add an 'on/off' indicator LED to the circuit? What rating LED should I get and where in the downloadable diagram should I wire it?

Report message to a moderator

Re: Where in the diagram can I add an LED? [message #830]

Thu, 09 September 2004 13:00

dann
Messages: 772
Registered: December 2002
Location: Austin TX

Senior Member

So, to add an LED on/off indicator, youll need to use a 3PDT stomp
instead of the DPDT stomp that was (most likely) included in your kit...

small bear electronics sells them, and/or we can send you one for about the same price (email 4ms@commonsound.com if you want to work that out)

once you have the 3PDT, wire it up like Step 3 in this diagram:

http://commonsound.com/swash/tame_trouble.pdf

you can just ignore step 1 and step 2, and ignore the Tame/Trouble flip switch as well as the low power pot.

make sense? good luck..

Report message to a moderator

Next Topic:

post pics of your 4ms pedals

Goto Forum:

-=] Back to Top [=-

Current Time: Mon Sep 6 20:00:58 EDT 2010

.:: Contact :: Home ::.